AussieCarHoists YL5000, Руководство пользователя

Страница: 25 / 33

24 / 32
7.9
Installation of the columns
•
Transport the columns to the located site.
•
Move each column toward the respective end of the transverse beam until stopped by the
slide blocks on the transverse beam. Make sure that the power-side column is positioned
in the correct location.
•
Incline the column at an appropriate angle and insert the bolted end of the safety rack into
the top cap of the respective column from its bottom. Make sure to use caution to prevent
columns from falling over. Do not use too much force to bend the rack during installation.
•
Fix the racks onto the top cap of the respective column as shown in the below picture
using the included nuts and washer.
•
Adjust each rack in equal height by tightening or unloosing the adjusting nuts.
•
Fix the bottom of the rack on the column using the included screw as shown in the below
picture.
•
Install the steel cables onto the top cap of respective column as shown in the picture using the
included nuts and washer.
•
Adjust each cable in equal tension by tightening or unloosing the adjusting nuts.
Screw
7.10
Anchoring the columns
•
Before proceeding, check the measurement referring to the layout and make sure that the
base plate of each column is square.
•
Using the base plate as guide, drill each hole in the concrete approximately 120mm deep
with the rotary hammer drill
D.
16. To assure full holding power, do not ream the hole or
allow drill to wobble.
•
After drilling, remove dust thoroughly from each hole using compressed air or wire brush.
•
Assemble the washers and nuts on the anchors then tap into each hole with a hammer until
the washer rests against the base plate. Be sure if shimming is required, enough threads
are left exposed.
•
If shimming is required, insert the shims as necessary around the anchor bolts, the
columns will be plumb.
•
With the shims and anchor bolts in place, tighten by securing the nut to the base.