15.
Slide the front of the tonneau cover into the rope track
as shown in Figure 9
and centre the cover. Drape the
cover over the
cab.
16.
Install the support bar (Refer Multi Fit Support Bar Page)
then drape cover over support bar and fit rear bunji's to
buttons on tailgate as shown in Figure 10
17.
To fit side buttons, work from the rear most bunjis
towards the front, alternating from side to side. Line up
the rear most bunji loop (#1) on the driver’s side of the
vehicle and make a mark on the line drawn in step 13.
18.
Drill hole, apply rust inhibitor and rivet button into place
.
19.
Repeat step 17 for the rear most bunji loop (#2) on the
passenger side of the vehicle.
20.
Fit remaining 8 bunjis following the sequence as in Figures
11 & 12.
Note: Ensure you work from side to side to maintain
tension across the tonneau cover.
21.
Cut 2 pieces from the supplied seal tape 270mm long. Use
the supplied Seal Template to mark and cut 1 piece to suit
the driver’s side of the headboard and 1 piece to suit the
passenger side of the headboard. Refer figure 13
Figure 9
Figure 10
Figure 12
Figure 13
Figure 14
