AUSA CH 200, Руководство оператора

Страница: 18 / 51

18
CH 200 / CH 250
Operating
the machine
Come in and come out of the forklift
Don't hold and pull of the steering wheel to come in/off the forklift, use the handles located on
the overhead guard and always support your foot on the rough bands of the step, to prevent any
downfall when you come in or come out.
Adjusting the seat and the steering wheel (figs. 1-2-3-4-5)
Before starting work with the forklift each day adjust the seat for the most comfortable position.
To move the seat backwards and forwards reach under the right side of the seat and locate a
small lever (1). Turn the lever and move the seat to the desired position. According to the weight
of the driver, set the seat with the lever (2). Normally it is adjusted for a driver weighting 198 lb.
To adjust the tilting backrest of the seat to your confort turn on the knob(3) (fig.4).
Securely fasten the seat belt.
To adjust the steering wheel in a comfortable position, loose this lever (5) move the column ade-
quatelly and tight it again.
Starting the engine
For safety reasons, when starting the engine the driver should be sitting on his seat, directional
control switch in neutral and the parking brake engaged.
Insert the key in the ignition switch, turn it fully clockwise and depress lightly the accelerator
pedal. At this moment the pilots of battery charge, oil pressure and pre-heat in the dashboard
panel will illuminate.
After some seconds, the pre-heat light will go off and the engine will start. When engine is run-
ning, battery charge and oil pressure lights will go out.
If the engine fails to start, repeat all above steps. Allow 30 seconds between attempts.
Important! With cold weather, before driving the machine, have the engine running some minu-
tes to improve oil circulation and lubrication.
WARNING
Before each period of operation, check the forklift for correct operation of
the steering, brakes, hydraulic controls, instruments and safety equip-
ment. Check the neutral position of directional control lever. A machine
that runs correctly is more efficient and can prevent accidents. Make all
necessary adjustments or repairs before you operate the machine.
(fig. 5)
(fig. 2)
(fig. 3)
1
2
(fig. 1)
1
2
(fig. 4)
3
3
ATTENTION
With ambient temperatures lower than 0ºC, AUSA recommends to run the
engine at idle speed for 3 minutes before starting to work with the forklift
in order to reach the appropiate fluency on the engine and hydraulic oil