AUSA CH 200, Руководство оператора

Страница: 17 / 51

17
CH 200 / CH 250
Instrument
Panel
and controls
Multifunction instrument
A - Hourmeter. This gauge indicates the total running time of the forklift engine to enable ser-
vicing of the engine at proper intervals. (See Maintenance Chart for servicing frequency).
B - Fuel level. This gauge indicates the diesel fuel level.
C - Fuel lamp. When the diesel fuel level is at the minimum level this alarm is lit.
D - Air filter lamp. When the air filter of the diesel engine becomes clogged with dirt, this
lamp will light. The air filter should be immediately cleaned or serviced.
E - Engine pre-heat lamp. When this lamp glows it indicates that the engine pre-heat plugs
are in operation and heating the combustion chamber to a temperature that will enable firing of
the vaporised diesel fuel.
F - Hydraulic oil lamp. When the hydraulic oil level is at minimum level this lamp is lit.
G - Oil pressure lamp. When this lamp is lit it means that the engine oil level is low
causing low oil pressure to the engine.
The engine should be stopped immediately to pre-
vent engine damage. Add oil to the engine until the proper level is reached.
H - Charge battery lamp. This gauge shows the condition of the battery and will tell you if
the battery charge is too low or if the alternator is not charging properly. Once the engine starts
to run, this red lamp will go out: If it remains lit, stop the engine and determine the cause.
J - Engine temperature lamp. This gauge shows the temperature of the coolant in the engine
cooling system. When this lamp glows it means that the engine is operating at high temperatu-
re which could damage the engine. The engine should be stopped immediately to determine
the cause of the high temperature. It could be low coolant, debris in the radiator or a thermos-
tat, which does not operate correctly.
K - Fast speed lamp (only CH200 and CH200 x4 wheel driving). This lamp is lit when the
faster speed is selected.
L - High beam lamp (with lighting equipment). This lamp is lit when high beams are selec-
ted.
M - Turn signal lamp (with lighting equipment). This lamp will blink indicating turn signals
are operating.
(fig. 2)
1