THE INTELLIGENT
MOTION SENSOR TRACKING LIGHT
INSTALLATION INSTRUCTIONS
Read all instructions before proceeding with the installation
OVERVIEW OF AEC-9339A
INSTALLING THE BULB
Unscrew the lamp cover of the luminaire and
install a 300W J-type lamp.
Re-fit the lamp cover and tighten the screws.
IMPORTANT: THE INTALLATION OF THIS FITTING MUST BE DONE BY A QUALIFIED ELECTRICIAN.
This fitting must be earthed.
Do not mount the luminaire against inflammable surfaces.
The motion detector will not operate correctly if it is installed:
(
) Near the outlet of a central heating boiler
Ⅰ
(
) Near air conditioning plant
Ⅱ
(
) Pointing directly at moving vehicles
Ⅲ
(
) Within sight of reflection from moving wa
Ⅳ
ter
(
) Where other lamps could shine onto the detector
Ⅴ
The maximum rating of this luminaire is 300 Watts. Check that the total load of the circuit. Including this luminaire.
Does not exceed the rating of the circuit cable.
NOTE:
This highly responsive unit may occasionally activate due to rapid environmental changes. Allow for approximately
30 seconds warm-up time before the sensor resumes normal activity.
Push-button
3 motion sensors
WARNING ! ! !
BEFORE ATTEMPTING ANY INSTALLATION OR
MAINTENANCE, ENSURE THAT THE
ELECTRICAL SUPPLY IS SWITCHED OFF AND
THE CIRCUIT FUSES REMOVED OR THE
CIRCUIT BREAKER IS IN THE “OFF”POSITION.
(DRAFT)
