Owner Handbook
Aurora Megacube X15
™
2
Revision 1
USE & MAINTENANCE
YOU MUST READ THESE WARNINGS
carefully because they include important
safety information about the installation, operation and maintenance of this
product. Follow all instructions to maintain Manufacturer Warranty and for your
own safety.
•
Read all instructions in this User Manual and on the product carefully
BEFORE
operating this device.
•
The latest version of this handbook can be found at www.lantalighting.com
•
All Lanta products can be used for indoor use. Under no circumstances must
these products be used outdoors unless stated otherwise.
•
To prevent risk of fire or shock, do not expose products to rain or moisture.
•
Make sure there are no flammable materials close to the unit during
operation.
•
Clean the product with a clean and dry, non-abrasive cloth. Do not use
solvents or liquids to clean the product.
•
There are no user replacement parts inside the product. Do not open the
product for any reason. This will invalidate your Manufacturer Warranty and
may impair the safety features of the product.
•
Do not use if the product if you suspect it has been damaged in any way,
including being dropped, is malfunctioning, or has been exposed to liquids
or moisture. The unit must be repaired by an authorised service centre only.
Manufacturer Warranty is void if unit is opened or adapted in any way. Operator
safety may be compromised if this product is not operated and maintained
in accordance with the details contained in this Owner Handbook.
•
This appliance must be earthed. Do not remove the earth connection in the
plug or any other location - it is essential for user safety.
•
Power connection to the product is via a UK 240 Volt AC three-pin mains plug.
Do not remove or adapt this plug. If necessary, only replace the plug top fuse
with one of the same type, size and value.
•
Be aware that products are mains powered and may be capable of
producing high voltages from its outputs and has mains voltages inside the
cabinet.
MAINS WARNINGS
•
Always make sure that the mains voltage you intend to use is within the
operating range of the product.
•
Always unplug product from the mains supply before moving, cleaning etc.
•
Make sure you replace the fuse with another of the same type and rating.
•
This product will be irrevocably damaged and the warranty invalidated if
connected to a power pack or other dimmer.
•
Make sure the mains cable is not crushed or damaged.
•
Never disconnect the mains lead by pulling or tugging on the cable.
•
This appliance must be earthed. Do not remove the earth connection in the
plug or any other location - it is essential for user safety.
•
Unplug the product from the mains during lightning storms or periods of
mains fluctuations. If the product is going to be unused for long periods,
unplug from the mains.
PHYSICAL WARNINGS
•
Always secure the product to a fastening device using a safety chain.
•
If the product appears to be malfunctioning or operating in an unexpected
manner, stop using the unit immediately and contact your supplier.
•
Never lift, move or carry the product by any other means other than the case
as a whole or handle if provided.
LASER WARNINGS
•
Lasers are hazardous devices. Permanent eye injury and blindness is possible
if lasers are used incorrectly.
•
Avoid direct eye contact with laser light.
•
Never intentionally expose your eyes or others to direct laser light.
•
This laser product can potentially cause instant eye injury or blindness if laser
light directly strikes the eyes.
•
It is illegal and dangerous to shine a laser into audience areas, where the
audience or other personnel could get direct laser beams or bright reflections
into their eyes.
•
It is illegal to shine any laser at aircraft.
•
Never leave this device running unattended.
NON INTERLOCKING HOUSING WARNINGS
•
This unit contains hazardous voltages, moving parts and high power laser
emitters.
•
Do not open the laser housing to avoid potential exposure to unsafe levels of
laser radiation.
•
The laser power levels, accessible if the unit is opened, can cause instant
blindness, skin burns, and fires.
LASER SEFETY NOTES
YOU MUST READ THIS LASER SAFETY INFORMATION
Laser light is many thousands of times more concentrated than light from
any other kind of light source and as so it poses a real danger to the sight.
This concentration of light can cause instant eye injuries, primarily by burning
the light sensitive portion at the back of the eye called the retina. Even if you
cannot feel “heat” from a laser beam, it can still potentially injure or blind you or
your audience. Even very small amounts of laser light are potentially hazardous
even at long distances.
Laser eye injuries can happen quicker than you can blink.
•
Entertainment products split the laser beam into hundreds of smaller laser
beams that are radiated out at high speed. There is a misconception that
an individual laser beam is safe for eye exposure. This is not the case. This
product produces high levels of laser power - classified as Class 3B - before it
splits into multiple beams - defined as Class 3R levels. Many of the individual
beams are potentially hazardous to the eyes and should never be directed
into an audience at any time.
•
Do not assume that because the laser light is moving, it is safe. It isn’t, and
because these beams are being moved by a mechanical device, it is
possible for that device to stop moving and then direct the laser beam
constantly at an individual. Since eye injuries can occur instantly, it is critical
to prevent the possibility of any direct eye exposure.
•
It is illegal to aim a Class 3R laser into an area where people could be
exposed, even below people’s eye level.
•
Always install a laser effect to ensure that the entire laser light radiation is at
least 3 meters above the floor on which people can stand. It is very important
to test the laser before any public use.
•
Do not use if any defect is detected such as if the product emits only one or
two laser beams rather than the expected quantities as this could indicate
damage to the product and could allow emission of higher laser levels
above Class 3R.
•
Do not point lasers at any reflective surfaces such as windows, mirrors
and metal truss or other reflective fixtures as even laser reflections can be
hazardous.
•
The operation of a class 3R laser show is only allowed if the show is controlled
by a skilled and well-trained operator, familiar with the data included in this
manual.
•
The law is updated from time to time and it is the users sole responsibility to
understand the legal obligations and responsibilities in force at the time and
location of use.
We recommend visiting the Government Health & Safety website
http://www.hse.gov.uk
or search for
“C ontrolling the radiation safety of display
laser installations”
for further information.