Aurora AU 3080, Руководство пользователя

Страница: 10 / 12

AU
3080
Hair clipper set
ENG
10
ADJUSTING THE BLADES
The profiles of the teeth of both blades when
you install must match exactly. The upper edge
of the real teeth (external) of the blade must be
nominated by approximately 1.2 mm above the
edge of the movable teeth (internal) of the blade,
as shown in the figure. If the blades are not set
correctly, apply a few drops of oil, turn the clipper
for a few seconds, then turn it off and disconnect
from the mains. Loosen the two screws securing
the fixed (external) of the blade and re him. Ef­
fortlessly, tighten the screws.
LEVER BLADES MOVE
Arm movement of the blade located on the left
side of the machine and makes it easy to adjust
the length haircut. During mowing, you can press
the lever gently to change the length of cut hair
without the use of additional accessories. At the
top position of the lever will receive a short hair­
cut. In the lowered position of the lever length of
the cut hair is the same as when using a nozzle
of 3 mm.
GETTING THE BEARD
The best cutting results are achieved when us­
ing dry hair. For the first time better to leave after
shearing longer hair. Hair length depends on the
nozzle. Install the nozzle on the blade. For even
cutting smoothly move the car through the hair,
do not make sudden movements, cut off one
pass a small amount of hair, if necessary return to
the treated area hair re haircuts. Remove cut hair
from the blades of the machine. Comb hair comb
to detect uneven strands.
STEP 1
Set the nozzle 1 (3 mm) or 2 (6 mm). Plug in the
power cord and turn the machine switch. Keep
the machine so that the blade facing upward.
Start a haircut from the beginning of hair growth
(Fig. 1). Slowly move the clipper upward and from
the head. Cut the thus all the hair from the bot­
tom and back of the head around the ears.
STEP 2
Turn off the machine, set the nozzle for longer
hair 3 (9 mm) or 4 (12 mm) and continue cutting
hair near the crown of the head (Fig. 2).
Step 3
Mowing in temples. For the topiary in the tem­
ples, set the nozzle 3 (9mm) or 4 (12mm), start
from the beginning cut temples and continue
towards the top (Fig. 3).
Step 4
Mowing in the crown of the head. Using the
nozzle 3 (9 mm) or 4 (12mm), cut the hair in the
direction from the top to the crown, against the
direction of hair growth (Fig. 4). Hair can be cut
against the direction of growth and the direction
of growth, but remember that the hair is trimmed
against the direction of their growth will be short
hair trimmed in the direction of growth. Use the
nozzle 1 (3 mm) and 2 (6 mm) for a very short
haircut. To keep long hair, use a nozzle 3 (9 mm)
or 4 (12 mm). To leave longer hair, clamp the
strands of hair between the toes and cut them.
You can use a comb, lift the hair strands and cut
them over the machine comb (Fig. 5, 6). Always
start a cut with the back of the head. Comb hair
comb to detect uneven strands.