AU
3011
Cordless jug kettle
ENG
10
CARE AND CLEANING
Before cleaning, always disconnect the kettle
from the power supply, drain and allow to cool.
do not wash the unit and the power base with
the power of water.
Wipe the case and the power base with a damp cloth.
do not use wire brushes, abrasive cleaners, and
hard to clean the unit, as this may damage the
surface.
Clean the filter with a soft brush.
regularly сlean the kettle from scale special
means, following the instructions on the packag-
ing.
remove the kettle from the base.
Pour water into the kettle through the spout or by
opening the lid.
fill kettle required amount of water ranging from
0,5 (MIn) to 1,7 (MAX) liters guided by the mark-
ings on the scale of the water level.
Place the kettle on the stand. Connect the power
cord to the power outlet.
A beep sounds, the number “
188.
” will appear on
the display. After a few seconds, the numbers will
go out.
Pressing the button 11 “
” is displayed number
100
(which corresponds to 100° C) The product is
made of boiled water. After reaching the desired
temperature, you hear three beeps, a kettle will au-
tomatically switch off, the display turns off.
during boiling, pressing the button 9 “
” in the
bottom right corner of the display will turn on the
indicator light, which corresponds to the water
heating mode. After boiling water kettle automati-
cally switches to hot water mode, the display will
show the number
60
, which corresponds to 60°
C. If necessary, you can increase hot water tempera-
ture using the keys 8 “ ”, or reduce by pressing the
key 10 “ ” each time the key 8 “ “ or 10 “ “ the
temperature increases or decreases by 5° C. The
minimum temperature in the water heating mode
is 45° C and 90° C maximum. Also, you can monitor
the water temperature once by pressing the but-
ton 10 “
” or 8 “
”.
In order to exit the temperature maintenance, you
just press the button 11 “
” or remove the kettle
from the base.
To prevent overheating of the kettle should not
pour water below the mark “MIn”. do not pour
water above the mark “MAX” differently at boiling
water can pour out through the spout.
do not leave the product unattended.
do not allow children to play with the product.
do not place the product on hot surfaces or near
heat sources.
Use the product only with the base supplied.
do not remove the kettle from the stand while
working, first turn it off. do not turn on the kettle
without water. Before turning on the kettle ensure
that the cap is tightly closed, otherwise the auto-
matic cut-out work at boiling.
The product is intended for heating water only, do
not use it for another purpose.
ATTENTION!
your kettle is equipped with thermal
protection. If the kettle is no or little water, it will
automatically turn off. If this happens, you must
wait at least 10 minutes to cool tea, then you can
pour water. If the kettle boil and turn off automati-
cally, but you need to heat the water again, wait 5
minutes before turning it on again.
USING THE APPLIANCE
