3
User Guide
Front ASP-882A
Front
Power – Power switch for turning the unit on or off. When first turned on all Input and Output
LEDs will light for 1 second to show operation of LED working.
LCD Display – Top row shows the input routed to relative Output number below.
EDID – Utilized for setting up the EDID management.
Save – Preset save function. Press Save for 3 seconds then an Input or Output number to
store a preset into one of the 16 locations of the current routing setup.
Recall – Preset recall function to restore a saved preset from one of the 16 stored presets.
Also, if press and held for 5 seconds with USB memory stick inserted with firmware file, the
unit will update the firmware.
Route – When pressed a user can set up any input to any outputs followed by enter for all the
routes to happen at the same time.
Enter – Used to confirm entries. Also, if pressed with nothing selected, it will show the units
Output connected status, Input connected status, IP address, Subnet Mask, Gateway, MAC,
and Firmware on the LCD.
Input 1-8 – Input source selections and used with various modes of operation.
Output1-8 – Output source selections and used with various modes of operation.
Note: Make certain you have the latest firmware for optimal performance and features listed in
manual.
