Aurora Archer IS007, Инструкция по установке и эксплуатации, Страница: 32 / 44

1. Main Electrical power supply must always be switched on to the unit with the two burner switches in the off
position (up) before commencing lighting the heater.
2. Turn on main gas supply.
3.
Verify that main electrical supply is switched on by checking the 240V AC power status display (Item 3)
indication is on.
4.
Burner selection: select low burn, medium burn, or high burn. Low burn switch (Item 1) controls the f r o n t
burner only. Medium burn switch (Item 2) controls the rear burner only. When both switches are down, they
will activate both the low and medium burners, which is the high setting.
5.
Heater operating LED sequence (Front Display Panel). Before commencing ensure that the power L.E.D
(Item 3) is on and burner switches are off. Switch on the heater by engaging the low and medium burner
switch, this will activate the pressure switch and the flue fan L.E.D (Item 4) will be on. Also the two burner
L.E.D’s (Items 5 & 6) will commence flashing for 35 seconds prior to ignition. Once both burners have
ignited the burner L.E.D’s will remain on. If you cant see flame on the rear burner, but the burner L.E.D is on
then there will be flame there, which will become more visible as the heater warms up. Once the heater warms
up the low speed L.E.D (Item 7) will light and the convection fan will blow warm air from the heater, as the
heater becomes warmer the medium L.E.D (Item 8) will come on and when the heater has reached its highest
operating temperature all three L.E.D’s (Items 7, 8 & 9) will light up and the convection fan will now be
running at its high speed. Refer Page 32 - Fan Operation. When the heater has been running for some time, the
water pump L.E.D (Item 10) may come on to signal that the pump has been activated.
Refer Page 28 - Automatic Humidifier Operation.
Note: Three heat settings are available for operating your Archer heater - low, medium and high.
a) Low setting (front burner only) - engage low burn switch only (Item 1)
b) Medium setting (rear burner only) - engage medium burn switch only (Item 2)
c) High setting (front and rear burners)
LIGHTING INSTRUCTIONS
31
Caution: When switching from the front burner to the rear burner, be sure to activate the rear burner first , then turn
off the front burner. When switching from the rear burner to the front burner, be sure to activate the front burner
first. Simple rule - always activate the desired burner first, then switch the other burner off. If it is switched the
wrong way the burner/s will go out and the heater may need to be reset. Refer Page 34 - Resetting the Heater.
Water Pump (10)
240V AC Power (3)
Flue Fan (4)
Front Burner (5)
Back Burner (6)
High Speed (9)
Medium Speed (8)
Low Speed (7)
Low Burn Switch (1)
Thermostat Display Mode
Button (Refer Page 27)
Medium Burn Switch (2)