~ 14 ~
The linking line will change to yellow.
Group setting
First select output ports one by one. Then select the input source. The selected output
ports change the setting at the same time.
By using Terminal
Baud rate: 9600
Data length: 8bit
Parity check: No
Stop bit: 1
RS-232 DB9 Pin Definition
Pin 2 Tx
Æ
, Pin 3 Rx
Å
, Pin 5 Ground
Command Set:
!
is the start character to active a command
?
is the start character to query status
~
is the start character of the response
/x0D
(<cr> aka carriage return) is the end character
COMMAND
ACTION
COMMAND
ACTION
COMMAND
ACTION
!R
Change Route
?R
Query route
!P
Preset recall
VR
Firmware Version
Examples:
To route input 1 to output 3, 4, 5, the command would look like:
!R1to3,4,5<cr>
The response is
~R1to3,4,5<cr>
Use a zero to remove a routed signal to an output. For example, to remove the route from output
3, 4, 5, the command would look like:
!R0to3,4,5<cr>
The response is
~R0to3,4,5<cr>
A query could be
?R1<cr>
Example response would is
~R1to3,4,5<cr>
To trigger a preset, the command would look like:
!P01<cr>
The response is
~P01<cr>
