Auriol 4-LD4437, Инструкции по использованию и безопасности

Страница: 9 / 62

- 7 -
Alarm
The weather station has 2 alarms, which can be set separately. Press the
MODE
-button
15
to select alarm 1 or alarm 2.
The corresponding alarm symbols will appear. When displaying alarm
1
or alarm
2
, press and hold the
MODE
-button
15
, to enter setting mode. The hours will blink on the display. Set the hours by pressing the -/ -button
11
or the
+/
12/24
-button
14
and confirm your setting by pressing the
MODE
-Taste
15
. Set the minutes in the same way. Press
the
AL/ON/OFF
button while displaying the alarm you wish to activate. Press the
AL/ON/OFF
-button
10
, to activate
(on)
or deactivate
(oF)
the alarm. If alarm
1
is activated the symbol will appear. If alarm
2
is activate the symbol
will appear. If no button is pressed within 5 seconds, the weather station will return to normal time display mode.
Snooze
Press the
SNOOZE/LIGHT
-button
12
, to temporarily deactivate the alarm. The bell symbol will blink on the display.
After 5 minutes the alarm will sound again. Press any button except
button 12
to shut off the alarm.
Weather forecast
The weather icons show a weather tendency for the next hours and not the current weather.
Should the forecast of your weather station be incorrect, you can adjust the display by pressing and holding the
HISTORY/WEATHER
-button
27
for 3 seconds. The weather icon will blink. You can now select the correct weather icon
by pressing the
°C/°F +
-button
28
or the
MAX/MIN-
-button
29
. Confirm your selection by pressing the
HISTORY/WEATHER
-button
27
.
Note: The weather station will start the forecast approximately 6 hours after the current weather was entered.
Sunny Downpour
Slightly cloudy Rain
Cloudy Snow
Barometer
Your weather station can show the air pressure tendency
25
.
Air pressure rising
Air pressure constant
Air pressure falling
You can also select absolute or relative air pressure by pressing the
Relative/Absolute
-button
30
. Rel. or Abs. will
appear on the display.
Note: The weather station measures the absolute air pressure. Your local weather service can supply you with the
relative air pressure for your location, which you can input into the weather station.
To change the relative air pressure, press and hold the
Relative/Absolute
-button
30
for 3 seconds. The air pressure
value will blink on the display and can be set by pressing the
°C/°F +
-button
28
or
MAX/MIN
-button
29.
Confirm
your setting by pressing the
Relative/Absolute
-button
30
.
Select the air pressure unit Hectopascal (hPa) or Inches of mercury (inHg) by pressing and holding the
°C/°F + -button
28
for 3 seconds.
12-hour air pressure history
Press the
HISTORY/WEATHER
-button
27
to view the air pressure history for the last 12 hours.
0 – HR = current air pressure
- 1 HR = air pressure 1 hour ago
-2 HR = air pressure 2 hours ago... and so on
Outdoor sensor/channel setting
You can use the weather station with up to 3 outdoor sensors at the same time. Open the battery compartment of the
outdoor sensor and select a channel (1-3) by using the channel switch
39
. Press and hold the
CHANNEL
-button
26
for
3 seconds or until an audible signal sounds. The weather station will now attempt to receive the signal
43
. Now press the