Auriol 365824 2010, Инструкции по использованию и безопасности

Страница: 45 / 60

- 43 -

adequate ventilation is always guaranteed (leave at least 10 cm space on all
sides);

the rain gauge is not hanging or standing in the immediate vicinity of magnetic
fields (e.g. loudspeakers);

no foreign bodies and coarse dirt can enter;

sensitive surfaces must be protected from scratches and water before installation.
Setup
Remove the protective film from the display of the radio-controlled weather
station.
Unscrew the housing of the rain gauge (
a
). Loosen the safety screw (
31
) on the
battery compartment cover and open the battery compartment of the rain gauge
( 30
).
Insert two 1.5 V AA R6 /LR6 batteries in the
correct polarity
.
Close the battery compartment. Assemble the rain gauge housing correctly. Make
sure that the 4 grooves on the housing match the 4 ridges inside the collecting
funnel (
26
). Close the housing again (
z
).
Open the battery compartment of the radio controlled weather station (
24
).
Insert two 1.5 V AA R6 /LR6 batteries in the
correct polarity
.
Close the battery compartment.
The display lights up for 5 seconds, an acoustic signal sounds and the radio
controlled weather station checks the indoor temperature and indoor humidity.
The radio controlled weather station then receives the temperature and amount of
rain from the rain gauge, the reception symbol (
21
) of the rain gauge flashes in
the display. This process takes up to 45 seconds. The radio symbol (
5
) then
flashes and the radio controlled weather station receives the DCF77 time signal.
First insert the batteries into the battery compartment of the rain
gauge (
30
)
and only then into the battery compartment of the radio
controlled weather station( 24
)
.