16
17
1 2
3
NOTE
Turn off the printer.
The self-test will print.
Press and hold the feed
button and power button.
1. For Hex Dump mode, do steps 1-2 then
press the feed button.
2. After printing ASCII pattern,
the diagnostic test is complete.
3. If the feed button is not pressed to go to
Hex Dump mode, the printer exits
diagnostics after three seconds.
4-8. Diagnostic Test
Self-Test Printout Sample
Upon initial installation or for
troubleshooting, you can run the
diagnostic test to get information about:
Firmware version, emulation, codepage,
sensor settings, interface settings, etc.
If no issues are found with diagnostic
test, examine other devices and software.
The diagnostic test is working
independent of devices and software.
●
Do not overheat the motor
To prevent the motor from overheating,
stop the printer for at least 30 seconds
after continuously printing 1.5 meters.
