MAG 4M 5026
User Manual
HOW IT WORKS
Jumpers 1 and 2 (see JP1 and JP2 in picture one) allow to set several kind of works for test and alarm
phase
.
FUNCTION
JP1
JP2
RADIO MODE
CLOSE
OPEN
CALIBRATION FOR MAGNETIC SENSOR
OPEN
CLOSE
NORMALY WORKING
X
X
RADIO MODE:
It’s a function used during learning procedure to get the radio code in the matched
receiver and to verify the quality of the radio connection. It starts from the closing of JP1 contact and
opening JP2.
The radio transmission is active for 30 seconds, modulated with a code set in the dip-switch(“LEARNING
AND RADIO TEST”).
At the end of transmission the magnetic contact goes in main working mode.
To start again the transmission, disconnect and fit again the JP1 contact.
CALIBRATION OF MAGNETIC SENSOR
:
It’s a function used during learning procedure of the
sensor that helps the installer to place the permanent magnet near the magnetic contact.
It is triggered by the closure of JP2 and JP1 open, the LED switches on when the magnet closes the
magnetic contact and switches off when the contact opens. No radio transmission is activated.
After five minutes from the starting of the procedure, the sensor will come back to the normal function.
To start again the function, disconnect and fit again JP2 contact
.
MAIN WORKING:
Normally is activated after the fitting of the battery or when “RADIO MODE” AND
“CALIBRATION OF MAGNETIC SENSOR” functions are finished.
The sensor sends a code set by dip-switch when the magnet is removed(see the paragraph “Code radio
features”) .
LED switches on for 100ms to show the radio transmission.
Note: The closing of the magnetic contact is not shown in anyway.
Luminous signal
Within the MAG 4M 5026 is present a red led which shows the follow functions:
It switches on in presence of any radio transmission( alarm signal, radio test).
In the case of discharge battery (under 2,3 V voltage level) it quickly blinks for two seconds each five
minutes.
In the “calibration of magnetic sensor” function , it switches on permanently if the magnetic contact is
closed.
The technical features can be change without forecast. AUR°EL S.p.A doesn’t assume any responsibility for the demages due to the improper use.
AUR°EL S.p.A.
Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY Rev.A 11.06.2014
Tel.: +390546941124 – Fax: +390546941660 Page 2 of
7
http://www.aurel.it
- email:
Preliminary
