AURATON S03 RT, Руководство пользователя

Страница: 16 / 24

16
2. On the receiver, press the button for 5 seconds until the trans -
mission ( ) symbol on the display is illuminated. Release the button.
3. Successful completion of unpairing is indicated by the LED diode no longer
blinking red and the repeater switching to normal operation.
In the event of an unpairing error, steps 1 and 2 must be repeated. If more
errors occur, all devices must be unpaired (see “RESET – Unpairing all
devices paired with the receiver”).
RESET – Unpairing all devices paired with
the AURATON RT receiver
In order to unpair all devices paired with the AURATON RT receiver, simul -
taneously press and hold both the pairing and the unpairing button ( and
) for at least 5 seconds, until the LED diode starts blinking green and red
alternately. Then release both buttons. Sound signal: when the button is
pressed, a short sound signal is emitted, followed by another short signal
5 seconds later.
Successful completion of unpairing of all devices is signalized after about
2 seconds by the diode color changing to green and then switching off for
a short time.
NOTE: If the power supply of the AURATON RT receiver is switched off and
then switched on after the RESET, the receiver automatically goes into
the “pairing” mode for 120 seconds. A newly purchased (separately
from the controller) AURATON RT receiver acts in the same way if it
has no factory-paired devices.