AURATON 3003, Руководство пользователя, Страница: 11 / 20

11
3. Place the expansion plugs into the drilled holes (plugs are
included in the kit) .
4. Fasten the rear panel to the wall using the screws included
in the kit .
5. Replace the front panel .
NOTE : In case of wooden wall you don't have to use expansion plugs. Just drill
the 2.7 mm dia holes (instead of 6 mm) in screw the bolts directly into the
wood
.
FRONT PANEL
REAR PANEL
Placing the front panel: NOTE
When replacing the front panel onto the rear panel pay attention to
the pin connection which transmits the control signals
.
Pins
Pin socket
When replacing the front cover make sure that the pins are
inserted into the pin socket.
10
battery
compartment
2x AAA 1.5 V
Put two AAA 1.5V batteries into the
compartment, observing the polarity.
To fasten the AURATON 3003 controller to the wall: :
1. Remove the controller front panel (as shown in the section
”Connecting the leads to AURATON 3003”) .
2. Drill two 6mm dia holes in
the wall (set the holes spacing
using the controller rear panel) .
Fastening the controller on the wall
NO
COM
NC
opening
for the screw