7
2.4
CEILING MOUNTED INSTALLATION
WARNING
Heater should be hung using rigid mounting brackets, the unit must not
be able to swing in any direction under applied load from wind or
persons. It is highly recommended that users install the heater with the
ceiling mounting hardware provided.
HEATER POSITION MUST MAINTAIN A MINIMUM CEILING CLEARANCE OF
0.3m (1’)
1.
Assemble the ceiling mounting hardware as
shown in the guide below. The socket head cap
screw should be used on the ceiling bracket
side, and the hexagon head cap screw should
be used on the heater bracket side for
clearance purposes. See Illustration.
2.
Secure the heater to the mounting brackets
using nuts and washers provided.
3.
Select the installation location on the ceiling by
identifying the studs or structural beams that
will allow the heater to be securely attached.
NOTE:
ceiling bolts or anchors are not supplied.
Select an appropriate size to provide adequate
support for the weight of the unit (14.3lbs /
6.5Kg) and take into consideration any wind load
conditions.
4.
Attach the unit to the ceiling using the ceiling
brackets and user selected bolts. An illustration
of the bolt pattern dimensions is shown to the
right.
5.
The heater can be hung vertically or pointed at
a maximum angle of 45° from vertical.
NOTICE:
NEVER direct the infrared heat produced
by the appliance at an adjacent wall.
6.
Secure the electrical supply cable so it does not
contact with the heater body or cover the
heater air vents.