4. Connect the red wire
(A7)
to the ACC terminal of the ignition switch.
5. Connect the black wire
(A8)
to the metal part of the car body.
6.Connect to the remote turn-on input of the amplifier or the antenna motor control input
7. Connect the rest of the wires according to the diagram.
1. Make sure that the on-board voltage of your vehicle is +12 volts
2. Remove the fuse from the device before connecting the wires.
3. Connect the yellow
(A4)
wire to the +12 Volt DC power circuit.
Note:
every time the yellow wire is disconnected from the 12 volt power circuit or the battery
terminal is removed, the device will revert to the factory settings.
fuse
15 A
Antenna connection input
radio receiver
RCA front – Left (white)
RCA rear – Right (red)
RCA rear – Left (white)
RCA front – Right (red)
ISO Connector
power and acoustic systems
RED
ACC +12V
YELLOW
constant
power
+12V
BLACK
ground
MINUS
BLUE
control
wire
+12V
Front speakers
B5
Left c (white)
B8
Left channel – (green-black)
B6
Left channel – (white-black)
B3
Right c (grey)
B2
Right channel – (purple-black)
Rear speakers
B7
Left c (green)
B4
Right channel – (grey-black)
B1
Right c (purple)
WARNING
DO NOT OPEN
5
Connection
MIC
- external microphone input (included)
SWC
- steering wheel control wired adapter input (not included)
Subwoofer L
- left RCA subwoofer output (white)
Subwoofeк R
- right RCA subwoofer output (red)