4
Handset Configuration
The screen shows the current values. To save a new value, press enter after changing the value. If value is out of range
the unit beeps.
Sleep Timeout
The time (seconds) taken for the unit to power off when not in use. Default is 120. Range 1-999.
Contrast
LCD display contrast. Default is 50. Range 1-100.
Backlight
Sets the default backlight level. Default is 0, which is off. Range 0-100.
Note, backlighting the display will reduce battery life.
IR spacing
Time (milliseconds) between IR messages when sending in macro mode. Default is 4 = 400ms spacing. Range 1-
99.
IR tx power
There are 3 infrared transmit settings; Low, Med and High. Range: Low - 8m, medium - 15m and high - 25m.
Default is Medium.
Key Click
Adds an audible beep when a key is pressed. The larger the number the louder the beep sounds . Use 0 for no
key click. Default is 2. Range 0-100.
Key Repeat
The repeat rate (milliseconds) for a key that is held down. Default is 10. Range 1-99.
Repeat Send rate
When ‘Send’ is held down, eg for Lux up, it is the interval between IR messages (milliseconds). Default is 22.
Range 1-99.
Mute
Disables all sounds. Default is No.
To Bootloader
Resets the handset. Used for updating the software (see ‘Updating UNLCDHS software‘ section of this
document).
To view Bootloader and Software versions, select ‘To Bootloader’ then turn handset on. The version
information will then be displayed.
To return the handset to the Config defaults. Hold button ‘1’ while turning the handset On until the ‘Product
Family’ menu appears on the screen.
Security
Enter PIN
When a special PIN number is entered the user can then access advanced Rapid programming menus and
send specific IR codes. Contact Technical support for details.
Handset Test
Factory use only.
Note
Changes to Sleep Timeout, Contrast, Backlight are applied after Off/On cycle. Changes to the rest take effect
immediately.
HANDSET CONFIG
Sleep Timeout
120
Contrast
50
Backlight
0
IR Spacing
4
IR TX Power
Med
Key Click
2
Key Repeat
10
Repeat Send Rate 22
Mute
No
To Bootloader
Security
>
Handset Test
>
Handset Config screen
