Laminating is an extremely fine and technical work, for beginners, need to laminate
under guidance of the experienced technician, the general operation is as below:
Preheating
Preheating
Preheating
Preheating::::
1. Down the upper roller;
2. Press the "Continuous" and "Forward" switch, Speed to "1";
3. Turn on the main switch;
4. Turn "hot" and set the required heating temperature, then roller began heating. The
preset temperature usually is 50
℃
, (it takes about 10-15 minutes for the heating)
5. Take one roll film and put into film roller, then put the film roller in the racks, and
pull the film with the hand to ensure the appropriate resistance
6. Put the laminating materials on the paper roller and fix it rewinding racks.
When
When
When
When the
the
the
the upper
upper
upper
upper roller
roller
roller
roller temperature
temperature
temperature
temperature to
to
to
to the
the
the
the set
set
set
set temperature:
temperature:
temperature:
temperature:
1. Press the "Inching" switch and then roller will stop turning.
2. Remove the press-paper roller and lift the upper roller.
3. (cold film installation) Cold film used for cold laminating, generally not need to
heat, but if the upper roller heating to 40-50
℃
, the laminating quality will be better.
pull the film and across the two rubber roller to stick it on the roller for
gathering-laminated-paper(for the beginner), or someone pull it, after laminated to
quickly stick on the roller for gathering-laminated-paper. In proper position to
separate the film and back paper, make the back paper on the back-paper roller. Note:
when the back-paper and film separate, make the film stick on the rubber roller very
smoothly.
4. Put the needed laminating paper on the front working-table, insert the blank of
paper in between rollers , then put press-paper roller.
Note:
Note:
Note:
Note: Make
Make
Make
Make both
both
both
both edges
edges
edges
edges of
of
of
of the
the
the
the p
p
p
paper
aper
aper
aper vertical
vertical
vertical
vertical with
with
with
with rubber
rubber
rubber
rubber roller
roller
roller
roller in
in
in
in
order
order
order
order to
to
to
to
make
make
make
make
the
the
the
the laminating
laminating
laminating
laminating straight.
straight.
straight.
straight.
5. Down the upper roller by handwheel.
6. Press the "continuous" switch and began to laminating.
Note:
Note:
Note:
Note: if
if
if
if the
the
the
the hot
hot
hot
hot film
film
film
film not
not
not
not tighten
tighten
tighten
tighten,,,, clockwise
clockwise
clockwise
clockwise move
move
move
move handwheel
handwheel
handwheel
handwheel to
to
to
to increase
increase
increase
increase friction
friction
friction
friction....
7. Clockwise move the speed knob to adjust appropriate speed.
8. If the film fold clearly, cut the film and again do the above steps.
When
When
When
When film
film
film
film laminating,
laminating,
laminating,
laminating, should
should
should
should note
note
note
note the
the
the
the five
five
five
five points
points
points
points::::
1.The film should be wrapped around the roller.
