Audley ADL-1600C1, Руководство пользователя

Страница: 12 / 12

Problem
Problem Problem
Problem R
R R
Reason
eason eason
easonssss M
M M
Method
ethod ethod
ethodssss
Control panel have no
electricity
Power is off or “emergency”button down Check the power and emergency
button
Fuse tube broken Check and replace insurance pipe
Don’t turn
Force between rollers too large Lift a little the upper roller
Friction is too large Adjust friction
Motor key loosen or fall off Tighten sprocket key
Motor or speed knob get problem Contact with motor or governor
Laminated paper isn't clear
and have white point
Roller temperature is not enough Increase roller temperature
Dust on the paper Clean the dust
Film quality not good Contact suppliers to replace film
laminated paper have
pleated bubbles
Roller’s force is not uniform or too much Adjust roller force
Paper not flat Put paper in 90 angle into rubber
roller
Speed slow and temperature too high Increase speed and reduce temperature
Press-paper roller not in the right position Press-paper roller fully touch paper
Laminated paper continuous
running aslant
Roller force is not evenly on both sides Adjust the roller force
Paper at first not straight Make the paper straight
Film fold
Film tension is too small Adjust material-roller’s resistance
The upper roller's temperature too low Adjust to the required temperature
laminated paper curly
seriously
Film's tension is excessive Adjust to suitable tension
The winding tension is too large Adjust to suitable tension