Auditronics 220 Digital Audio Console, Техническое руководство, Страница: 18 / 109

I N S T A L L A T I O N a n d P O W E R
page 1 – 9
220 / March 2000
(2) The terminal conductor tabs with stripped wire
are placed in anvil 26-28.
HAND CRIMP TOOL WIRING INSTRUCTIONS
The supplied hand crimping tool (W/S#850068) is used for all I/O wiring
connections to and from the console. It is to be used with the supplied pin
(figure 1) intended for 24"-28" gauge wire.
1) Strip wire approximately 3/16" (insert in
proper wire stripper, rotate one half turn, and
pull insulation off wire).
2) Insert wire into terminal until wire
insulation is stopped by conductor tabs, and
place the conductor tabs on the anvil marked
as 26-28 (figure 2).
3) CRIMP by squeezing handles until jaws
are fully closed to secure wire in the terminal
(figure 3).
4) If there is an insertion error or if a
circuit change is needed, you'll need to use
the supplied pin extractor tool (W/S#850069)
to remove terminals, and correct your mistake
without having to sacrifice a connector. Place
extractor tip (red side) over pin terminal to be
removed (figure 4), and press it downwards
motion until tip rests upon Housing. Then
pull out the pin terminal from Housing. It
should never be necessary to discard a con-
nector due to a wiring error.
Note that metallized plastic hoods for
each connector are also supplied with the
console.
(3) Jaws fully closed; the insulation tabs have
been crimped.
(1) Pin crimp terminal
CONDUCTOR
TABS
INSULATION
TABS
INSULATION
STOPS HERE
(4) Place extractor tip over pin terminal to be
removed.