Audison Thesis HV venti, Руководство пользователя, Страница: 12 / 25

1 •
2 •
3 •
4 •
5 •
6 •
7 •
- POWER (GROUND)
Terminal block for the amplifi er power supply negative pole connection. Connect the battery negative cable or the one
connected to the vehicle chassis to it. Holes have 9.5 mm (.37 inches) diameter and accept cables up to 2 A.W.G. For
better current transfer, power supply cables have to be as big as possible.
- CAP (18V min)
Terminal block for connecting the negative terminal of a possible external capacitor. The capacitor working voltage
must be 18 Volts min.
LIGHT ON - GND -
Terminal block for amplifi er internal light. Connect it to the car chassis to lighten the product. You can remotely control
the lighting system through a switch or you can connect the terminal block to the ground switch which activates light
in the trunk.
REM IN (7 ÷ 16VDC)
Terminal block for connecting the Remote cable which comes from the source and controls the amplifi er switching on.
Applied voltage must be between 7 and 16 VDC.
12VDC 600mA
DC connector for a 600mA, 12V external power supply which switches on the amplifi er internal light, including the
Status Controller, activated in demo confi guration. This function is only cosmetical; LIGHT ON – GND – terminal block
doesn’t need to be connected to the chassis.
+ CAP (18V min)
Terminal block for connecting the positive terminal of a possible external capacitor. The capacitor working voltage must
be 18 Volts min.
+ POWER (11 ÷ 16VDC)
Terminal block for the amplifi er power supply positive pole connection. Connect the car battery positive cable to it.
Holes have 9.5 mm (.37 inches) diameter and accept cables up to 2 A.W.G. For better current transfer, power supply
cables have to be as big as possible.
- 11 -
POWER SUPPLY - SWITCHING ON PANEL OWNER’S MANUAL
2