70
USER'S MANUAL
The POP UP menu allows a 360 ° use of the main functions through
the functions that can be activated via the Channel Map.
1)
MUTE:
Mute Enabled;
Mute disabled.
2)
SOLO:
Solo Enabled;
Solo disabled
3)
PHASE:
Phase not inverted;
Phase inverted.
4)
Multi Sel:
it allows the activation of multiple channels on the
Channel Map in order to display the total electrical response on
Channels EQ.
5)
Volume:
it manages the overall system volume.
6)
Volume Sub:
it manages the overall SUB level volume.
During the equalizer calibration, the display shows the changes that
are made to the electrical signal that is sent to the speakers via the
amplifiers in real time.
The actual audio signal reproduced by the system depends on the
type of speakers used and their positioning. To analyse the acoustic
response, use a spectrum analyser connected to a microphone.
Otherwise you need to make use of your experience
in listening and refine the calibration by relying on it.
The curve can be manually edited using the mouse pointer. To be able to vary the "F" G" and "Q" factors, you will just need
to act on the mouse wheel equipped with this function. A finer adjustment of these parameters can also be made using
only the PC keyboard
-
The keys
and
: allow the selection of the pole to be adjusted on the diagram. The successful selection
of the pole is displayed by a circle around it
-
Key
: allows the selection of the “F”,”G” and “Q” poles control point. The successful selection of the
control point is visible through the green color of the control slider.
-
Keys
+
and
+ .
1.
Flat / Reset:
it restores, if enabled, all the poles of the
parametric equalizer in the default position.
2.
Link L/R:
it applies, when active, the equalization curve
to both the right and left channels simultaneously.
3.
L->R R->L:
this function is active when "Link L / R" is
deactivated. By clicking on one of the two keys it is
possible to transfer the equalization curve of the Left
channel to the Right one and vice versa.
4.
Xover:
it displays the electrical response
subjected to filtering (XOVER), by clicking on the
box (red curve).
5.
EQ:
it displays the electrical response subjected
to equalization, by clicking on the box (yellow curve).
6.
SUM:
it displays the sum between the electric
response and the crossover, by clicking on the
box (purple curve).
7.
EQ Off:
when active, it allows the equalizer to be switched off.
8
Содержание bit One HD Virtuoso
Страница 1: ...USER S MANUAL rev 3 0 aidison com ...
