9b.
This procedure is only applicable for FS-QR with electronic height adjustment setting.
During testing the system is aready set to maximum limits.
For the first use the lifting head must be set in height to let the cams from the monitor
bracket insert into the key holes of the lifting head (while the flat panel is still in the
flightcase).
Be aware of adjusting the bottom height for the DFS before installing the
monitor!
Work along the below protocol to set the right height.
Adjusting new lower position (only upwards).
-
Plug in power and lower the lifting head to its lower limit.
-
Use the rear mounted transmitter to control he system.
-
Press the buttons UP en DOWN at the same time until the mounting head moves
up-and down shortly (program mode).
-
Press single up to set the new height.
-
For storing this position press the middle until the mounting head moves up-and
down shortly.
-
The new position is set.