Setting your personal code of the alarm.
(part.nr. 390409)
For setting the alarm code, slide the switch on the side upwards.
-Press the CODE key (middle lower button). The standard factory code is 111.
-When pressing that code, the alarm will confirm with 2 beeps.
-Choose your personel code (max 3 numbers).
-When pressing that code, the alarm will confirm with 2 beeps.
Your alarmcode is set. Press the red button for activating the alarm, and deactivatig it by
pressing your code (only the numbers).
When the batteries are removed more then 1 minute, the code will be 111 again.
Setting your personal alarm pattern.
It is possible to set a certain pattern.
Pattern:
1.
Duration of alarm 60 seconds
2.
Duration of alarm 60 seconds, 30 sec. pauze. This will be repeated 3 times.
3.
Duration of alarm 90 seconds, 30 sec. pauze. This will be repeated till the battery is
empty.
Press the red button followed by the right lower button (*). Then press 1,2 or 3 (see upper
patterns).
Adjusting the vibration switch.
(part.nr. 390414)
-Shut down the alarm first
-Remove the cover with a small screw driver.
-Change the tension of the spring loaded contact.
Note:
The setting must be checked in combination with the alarm.
Use hearing protection and warn your surroundings before setting the alarm.
Batteries:
The life time of the batteries can change according the type and brand to be used.
When the battery indicator is flashing, the batteries need to be replaced.
Use (3 x AAA) alkaline batteries for optimum performance.
