Wired FM Modulator
Your video system may be equipped with an RF
modulator, that allows you to listen to the VOH682s
audio signal by tuning your vehicles radio to the
selected frequency, (88.7 or 89.1 - Check with your
installer) and turning on the remote mounted RF
modulator switch. (In most cases this toggle switch
will be located underneath the drivers side of the
dash, check with your installer for the exact location.)
Whenever the RF modulator is on, broadcast radio
reception will be poor. Turning the remote mounted
toggle switch off will allow normal radio reception.
Audiovox Video Cassette Player (Aux Video 1)
In most installations a VCP will be connected to the
“Video 1” input. To view a video cassette, turn the
VOH682 On and press the source button on its control
panel or the TV / Video button on the remote control
until “Video 1” is displayed on the screen. The VCP
may also be operated with the remote or the buttons
on its face. The VOH682 is now ready to play the
audio and video signals from the VCP if it is connected
to the “Video 1” input. Inserting a tape into the VCP
will turn it on and automatically activate the play mode.
If a rewound tape had already been loaded into the
VCP, prior to its activation press play on the VCP or
on the remote control to view the tape. For more
information see the operator’s manual accompanying
your VCP.
Video Output
The VOH682 provides a video output for an optional
video monitor(s). (Refer to page 7 of the installation
guide for more details.) This output will provide a
video signal that duplicates the signal displayed by
the VOH682 to an additional monitor or video display.
Please see your installer for more information.
