Audiovox VE-560, Инструкция по установке и эксплуатации

Страница: 12 / 16

9
J. Battery Installation
a. Turn the Remote Control face down. Press the ridged area of the battery cover
and slide it off in the same direction as the arrow.
b. Install two AAA batteries. Make sure that proper polarity (+/-) is observed.
c. Slide back the cover in the contrary direction as the arrow until it clicks.
K. CHANNEL TUNING SET UP
In addition to normal broadcast reception of VHF and UHF channels, if you are a
Cable TV subscriber, your new TV is capable of receiving many unscrambled
Cable channels without the use of a converter box. When set to Broadcast TV it
receives CH2-CH69. When set to one of the CATV modes (STD, HRC, or IRC) it
receives CH1-CH125. Follow this simple procedure to make channel tuning more
convenient.
1. Use the TV/CATV button on the Remote Control to select the broadcast or
cable system appropriate for your home. The system selected will be displayed
on the screen. If you have an external roof mounted or rabbit ear antenna,
select “TV,” if you have CABLE TV, select either “STD”, “HRC” or IRC (“STD”
is used by the majority of Cable Systems. Check with your cable system
operator).
2. Press the AUTO MEMORY button on the Remote Control Unit or the TV.
You will see the TV cycle through all channels. The built-in Microprocessor
will automatically store each channel that is actively broadcasting in your
area.
3. To view only strong clear channels, press the SKIP/SEARCH button on the
Remote Control Unit until “SKIP MODE ON” is displayed on the bottom of
the screen. The TV will now tune only to strong, active channels, when the
UP or DOWN buttons are used on the monitor or remote control.
To view a weak or marginal channel, press the SKIP/SEARCH button on the
Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of
the screen. Tune to the desired channel using the CHANNEL UP/DOWN
button or go directly to the channel by direct access using the 0-9 buttons on
the Remote Control.
4. To ERASE a channel, press the ERASE/WRITE button on the Remote Control
Unit until “MANUAL MEMORY XX ERASE” is displayed on screen. To
STORE a channel, press the button until “MANUAL MEMORY XX ADD” is
displayed on screen.
b.
c.
a.