Audiovox SRANT-RMSIR, Руководство по установке

Страница: 6 / 12

5
There are two types of window moldings, used
on most vehicles. Both are suitable for conceal-
ing the antenna cable.
Figure 11: Outside rubber molding (most common)
Figure 12: Encapsulated molding (less common)
Note: The window molding will be more flexi-
ble and easier to work with at room temperature
or above. Ensure the molding is clean, and if
necessary apply a small amount of oil to make
the process easier.
Figure 13: Cables routed in standard molding
Figure 14: Lifting up difficult molding for routing each
cable in both directions
6. Route the cable from the lowest point of the
rear window into the trunk area. Take advan-
tage of any existing cable channel or wiring
conduit
.
Figure 15: Entering the trunk through cable channel
It is important that the coaxial cable is
not damaged or kinked during the instal-
lation procedure. Routing the cable in the
window molding will not affect the seal-
ing of the window.