Audiovox SRANT-RMSIR, Руководство по установке

Страница: 10 / 12

9
b. Alternatively, the cable may be hidden under
the rubber molding following the metal groove
underneath the molding to the interior.
Figure 30: Hiding the cable under the rubber molding
Figure 31: Going inside under the interior trim
7 Pickup Trucks
Figure 32: Pickup truck with antenna module
The antenna module should be mounted on the
centerline of the roof approximately 4 inches
from the rear of the cab.
The cables may be routed into the cab through
the brake light cavity.
1. Follow steps 1 to 4 under “Sedans” to attach
the antenna module to the vehicle .
Note: If the molding of the brake light is made
of rigid plastic/composite, it may be necessary
to drill a small hole or slot to route the cable.
Seal the hole with silicone compound after the
installation.
Figure 33: Brake light cavity
Figure 34: Completed installation
2.
Route the cable through the interior trim to
where the receiver is located.
3. S
ee Figure 19 under “Sedans” for connec-
tion to the receiver.
It is important that the coaxial cable
is not damaged or kinked during the
installation procedure.