Theater Sound System
INSTALLATION AND WIRING INSTRUCTIONS
AMPLIFIER MODULE
Mount the amplifier module in a location that is conveniently accessible to the rear speaker
wiring harness. It is these wires the RB-3600 interrupts. It is not necessary to mount the
amplifier module close to the television. Connect one end of the 10-pin cable assembly to the
amplifier module.
Cut the wires to the rear radio speakers. Connect the rear speaker(s) as follows:
Left rear speaker(s)
+
: white wire on 4-pin connector
Left rear speaker(s)
-
: violet wire on 4-pin connector
Right rear speaker(s)
+
: blue wire on 4-pin connector
Right rear speaker(s)
-
: green wire on 4-pin connector
The optional interface harness, that is available for some vehicles, will simply plug into the
OEM speaker harness. No cutting/splicing is necessary.
Connect the dash radio rear amplifier outputs as follows:
Left rear amplifier
+
: gray/white wire on 8-pin connector
Left rear amplifier
-
: gray wire on 8-pin connector
Right rear amplifier
+
: brown/white wire on 8-pin connector
Right rear amplifier
-
: brown wire on 8-pin connector
Connect 12 volt power to the RB-3600 as follows:
+12 volt power
: red wire on 8-pin connector
Ground
: black wire on 8-pin connector
Connect the Audiovox television external speaker output to the RB-3600 as follows:
External speaker output
+
: pink blue wire on 8-pin connector
External speaker output
-
: black/white blue wire on 8-pin connector
Unplug the audio output of the VCP. Connect the isolation transformer as follows:
Isolation transformer male RCA
: to VCP audio output
Isolation transformer female RCA : to RCA cable that was plugged into the VCP
