of 8 different sensitivity levels. To adjust or
change the setting of your shock sensor dis-
arm the system and within 8 seconds, simulta-
neously press both buttons of your transmit-
ter until the siren emits a low tone. This indi-
cates that the unit is ready to accept a sensi-
tivity level change. Press button #2 of your
transmitter to make adjustments. The siren
will emit a tone synonymous with the chang-
ing levels. The lower the tone, the lower the
setting, the higher the tone, the higher the set-
ting. While in the adjustment mode, strike a
support pillar of the vehicle, the unit will emit a
2 second tone indicating your setting. The
system will allow you to keep this setting or
make further adjustments. Once you have
reached the desired level, press button #1 to
lock in your setting. The siren will emit two
high chirps to confirm your setting is locked.
Follow steps 1-4 above to test the sensitivity
level change.
Remote Panic Operation
The alarm can be activated via the keychain
transmitter to draw attention to your vehicle
during an emergency situation.
To activate the panic feature;
A. Press and hold the arm/disarm button on
the keychain transmitter for 3 seconds.
B. The alarm will sound, flash parking lights
and continue for 60 seconds.
C. To silence the alarm before the 60 second
shutdown, press and release the arm/
disarm button on the keychain transmitter.
WARNING ! In most areas, it is illegal to
activate the alarm while the vehicle is moving.
For the safety of your passengers and other
motorists, do not activate the alarm while your
vehicle is in motion.
Override Switch Operation
If you lose or misplace your keychain transmitter,
or if the transmitter fails to disarm the system,
an emergency bypass switch is included to
temporarily disarm the system.
To use the switch;
A. Open the driver’s door. The alarm will sound !
B. Insert the key into the ignition switch, and
turn it to the “on” position.
C. Move the override switch to the “on” then
“off” position. The alarm will disarm, and
the vehicle can now be started.
INSTALLING THE WARNING DECALS:
Once you have confirmed the operation of your
security system, you may elect to install the
security systems warning decals. Typically
these decals are installed on the lower left of
the driver side and lower right of the passen-
ger side windows as shown. Remove the de-
cal backing paper and hold the ends of the
decal toward you. This will cause the center
to bend toward the window. Place the center
of the decal on the window and roll the sides
out one at a time. This will insure no air
bubbles get under the decal when affixing it to
the window. Once in place, smooth out the
entire label pressing it firmly to the window.
-9-
Содержание Rampage AA-939
Страница 11: ...11...
