CONGRATULATIONS On the purchase of your new Audiovox Alarm System.
Taking a few minutes to read this installation and owners guide will provide you
with the detailed information concerning all the features of your new alarm system.
MOUNTING THE SIREN:
1. Choose a location in the engine compartment
that is away from hot and moving parts,
considering the Red wire length must
connect to a battery positive source. Mount
the siren high enough to prevent access
from below the vehicle. Typical locations
are the inner fender well or the rear firewall.
2. Once you've selected a location, inspect
behind the area to ensure that drilling the
two holes required to mount the bracket will
not penetrate wiring or fluid lines.
3. Using the siren bracket as a template, mark
the two mounting holes with a scribe or
punch at your chosen location and drill two
3/16" holes on the pre-selected marks.
4. Using the two 1/4" x 1" screws supplied,
secure the siren mounting bracket in place.
5. Mount the siren to the bracket as shown
using the two nuts, washers, and lock
washers provided. Point the siren horn
(front) downward to allow the sound to
easily escape the engine compartment.
Note: If the bracket is mounted to a grounded
metal surface, secure the Black siren
ground when mounting the siren to the
bracket. If the bracket is mounted to
plastic or a non grounded surface,
connect the Black siren ground wire as
described in the following section.
2. Mounting the Override Toggle Switch
Select a flat area on the lower dash lip, where
the switch is readily accessible to the driver,
but will not be accidentally bumped. Other
alternate locations are on the driver’s side kick
panel, or the side of the lower steering column
cover.
Since this is a “protected” ( will only operate
when the key is in the ignition ) bypass switch,
it does not have to be concealed, however
concealing the switch is always recommended,
as this provides an even higher level of
security to the vehicle.
IMPORTANT ! Make sure there is adequate
room behind the panel for the body of the
switch in the selected location. You should
also be sure that the drill will not pierce any
wires, or damage other components after
passing through the panel. It is always best to
remove the panel from the vehicle before
drilling the hole.
To mount the override switch;
A. Drill a 1/4" diameter hole in the selected
switch location.
-2-
Содержание Rampage AA-939
Страница 11: ...11...
