background image

3. In 30 seconds, you will hear a single short chip from the siren, and the vehicle’s

parking lamps will flash one time, indicating that  the system has ARMED. At this
time, the red dash mounted L.E.D. will begin to flash slowly, providing a visual
indication that the system is fully armed.

4. It is possible to program the system, that when the alarm is allowed to automatically

passive arm, there will be a 15 second delay after a door is opened before the
alarm will sound. However, if the system is programmed for instant trigger there
will be no delay.  Check with your installer for the setting of this feature.

IMPORTANT! When the system is programmed for passive arming, the system

will always arm, even when the keychain transmitter has not
been used to lock the doors.

When you leave the vehicle, and a door has been left opened, the system will
arm after 10 minutes. If you plan to vacuum the car, or if service work is being
performed, either leave the key in the ignition and switched to the on position,
or put the system into valet mode. If you do not do this, the system will arm in
10 minutes, and you will probably inadvertently trip the alarm.

PROTECTION WHILE THE SYSTEM IS ARMED :

1. Opening any door, hood, or trunk will cause the alarm to immediately sound. The

alarm will continue to sound for 30 seconds, then stop and automatically re - arm
the vehicle. If the potential thief left a door opened, the alarm will sound for five more
30 second cycles, then re - arm and ignore the opened door zone.

2. Whenever the system is armed, the red dash mounted L.E.D. indicator will slowly

flash. This serves as a visual deterrent to the potential thief. The L.E.D. is a very
low current bulb, and will not cause the vehicle’s battery to drain, even when the
vehicle is left unattended for extended periods.

3. Whenever the system is triggered, the vehicle’s parking lights will flash for the 30

second alarm cycle, attracting added visual attention to the vehicle.

4. Whenever the system is armed, the vehicle’s starter will be disabled. The vehicle

will not start.

DISARMING THE SYSTEM :

1. As you approach the vehicle, press and release the unlock button on the keychain

transmitter.

2. The siren and or horn will beep two times, the parking lamps will flash two times,

and the red dash mounted L.E.D. will turn off, indicating that the system is
DISARMED.  If the optional entry illumination feature has been installed, the
vehicle’s interior lights will turn on for 30 seconds, or until the ignition key is turned on.

NOTE: If your system has been programmed for “ passive arming “, then it will

begin to re-arm immediately after disarming.  This is indicated by a

Page 2

Содержание Pursuit PRO 9232









Отзывы: