-7-
Engage right side first
Release Button
DETACHING THE FRONT PANEL
ATTACHING THE FRONT PANEL
co
TAPE SCAN
When the Scan button is pressed during tape play, the “SCAN”
indication will appear on the display panel and the first 10 seconds
of each selection on the tape will be played in order (“CASS” will
flash on the display panel as the selections are played). When a
desired selection is reached, press the Scan button again and
play of that selection will continue (“SCAN” will disappear from the
display panel). The Scan mode will also be canceled by activating
the Fast-Forward
br
, Rewind
bs
, Program Selector
bt
, or Repeat
Play
cm
functions.
cp
FRONT PANEL RELEASE BUTTON (REL)
This button is used to release the mechanism that holds the front
panel to the chassis. To detach the front panel, press the button
so that the left side of the panel is released. Grasp the released
side and pull it off of the chassis. To re-attach the panel, position
the right side of the panel in place first and then press the left side
of the panel until the mechanism locks it into place.
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-side-up when attaching it to
the chassis as it cannot be attached when up-side-down.
2. Do not press very hard on the front panel when attaching it to
the chassis. No more than light to moderate pressure should
be needed.
3. When attaching the front panel, make sure the right side is
correctly engaged before pressing the left side to lock it into
position.
4. When taking the front panel with you, please use the supplied
carrying case to protect the panel from dirt and damage. Make
sure there is no dust or dirt on the electrical terminals on the
back of the panel as this could cause intermittent operation
or other malfunctions.
