128-8783b
5 of 28
5
This Remote Start/Alarm System is designed to be used with
Automatic Transmission- Fuel Injection
Gas or Diesel Vehicles Only!
INSTALLATION OF THE MAJOR COMPONENTS:
CONTROL MODULE:
PART # 1365034
Select a mounting location inside the passenger compartment (up behind the dashboard). The mounting
location selected must be within 24" of the ignition switch wiring harness to allow connection of the 6 pin
main wiring harness. Be certain that the chosen location will not interfere with proper operation of the
vehicle. Avoid mounting the module to or routing the wiring around the steering shaft/column, as the
module or wiring may wrap around or block the steering wheel preventing proper control of the vehicle. The
module will be secured after all wiring is completed which will allow complete access until the job is done.
Do Not Mount The Module In The Engine Compartment
, as it is not waterproof.
HOOD PIN SWITCH:
PART # 1363699
The pin switche included in this package is intended for protecting the hood area of the vehicle. In all
cases, the switch must be mounted to a grounded metal surface. When the pin switch is activated, (hood
open), it will supply a ground to the input wire activating the alarm. In addition, the hood switch is required
for the safety shut down of the remote start unit. If the vehicle is being worked on, this hood switch
prevents the remote start activation even if the RF command to start is issued.
This switch must be
installed in all applications. Failure to do so may result in personal injury or property damage.
THE PUSH-BUTTONPROGRAM SWITCH/LED/RECEIVER/ANTENNA ASSEMBLY: PART #1181202
The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the
dash board for maximum operating range. Choose a location above the belt line (dashboard) of the vehicle
for best reception. Special considerations must be made for windshield glass as some newer vehicles
utilize a metallic shielded window glass that will inhibit or restrict RF reception. In these vehicles, route
the antenna toward a rear window location for best reception. Secure the antenna with double stick tape
provided.
WARNING!!
This unit is to be used in vehicles with
AUTOMATIC TRANSMISSIONS
only! Although this
combination Alarm/Remote Start unit is a sophisticated system with many advanced features,
IT MUST
NOT
be installed into a vehicle with a
manually operated transmission
. Doing so may result in serious
personal injury and property damage.
