4
Navigation Voice command display timer:
There is a three-position switch
located on the front right of the mirror/monitor. The three settings are 30 seconds,
150 seconds and 300 seconds. The vehicle operator can select to engage the
navigation display timer by pressing Sw 1. The navigation display will appear for
the preset time whenever the navigation system issues an audible voice command.
II. OPERATION
1.
The Mirror/monitor is ready for operation every time the Ignition key is
turned on.
The mirror/monitor turns off every time the Ignition is turned to the off
position.
2
. How to view the Navigation image
Press SW # 2 to see the navigation display continuously. Press SW #2 again to
turn off the navigation display. If you want to engage the navigation voice
command timed display, make sure SW#2 is pressed until the image is gone.
Then press SW# 1, the LED will turn yellow and the navigation image will
appear for the preset time when- ever the navigation voice command is heard
(30sec,2.5 minutes or 5 minutes).
III.
Cellular Phone Hands-Free Operation
1.
Attach the round metal adhesive disc to the back of your mobile phone while not
in use, and then attach the mobile phone adhesive magnetic mount to your
selected spot of the dash area. By placing your cell phone with the metal disc over
the center of the magnetic seat, your cell phone will be attached tightly to the
dash
2
.
Plug in the 2.5mm hands free cable into your cell phone headset jack. The other
end of this cable should be connected to the mirror jack. Note. If your cell phone
does not have a 2.5mm headphone jack then an adapter must be used for your
particular cell phone. Also not all cell phones are compatible with this mirror
hands-free circuit.
3.
To answer a call, press the receiving button on your cell phone as usual, the
hands free system will engage automatically.
4.
The volume of the other party’s voice can be adjusted by turning the volume
control under the bottom of the mirror on the right side. It may be necessary to
adjust phone volume.
