M-01334, Rev. B
Page 21
4.2
Connecting the Cables
Figure 4-7. Cable Diagram
Step 1
Attach the Antenna Control cable circular connector to the antenna. Be sure to rotate
the plug clockwise until the connector is completely seated. Connect the two RF
cables, RF1 and RF2 and slide weather bolt over the connections. (See Figure 4-1.)
IMPORTANT! IN SINGLE COAX INSTALLATIONS USE J3 NOT J2. FAILURE
TO DO SO WILL RESULT IN ERROR MESSAGE “CODE 10: LNBFV” ON
SCREEN.
Step 2
Route the RF coax cable and the antenna control cable down through the roof to the
receiver. A 3/4-inch hole must be drilled in order to pass the cables down through the
roof.
