INSTALLATION AND HOOK UP
1) Cut mounting hole in desired location using mounting hole
diagram (right).
2) Route power, speaker, and antenna cables through hole,
and connect to unit as shown in hook up diagram below.
3) After making sure connections are correct, test unit
operation as described in the operation section (Do not
mount until AM antenna trimmer adjustment has been
made.
NOTES:
- Speakers must have a minimum of four
Ω
impedance each.
-
Either antenna may be used. Both do not
have to be hooked up at the same time.
-
Do not operate this unit with only one
speaker hooked up. If a speaker fails,
replace it before operating this unit.
NOTE: Always be sure when running cables to avoid sharp edges, extreme heat sources, and any other
potential hazards.
2
COLOR
GREEN/WHITE
BLACK/WHITE
WHITE
VIOLET
LIGHT GREEN
RED
VIOLET/BLACK
YELLOW
LT.GREEN/BLACK
BLUE
ORANGE/WHITE
RIGHT (A) SPEAKER (-)
LEFT (B) SPEAKER (+)
LEFT (B) SPEAKER (-)
RIGHT (B) SPEAKER (+)
RIGHT (B) SPEAKER (-)
RIGHT (A) SPEAKER (+)
LEFT (A) SPEAKER (+)
LEFT (A) SPEAKER (-)
+12VDC IGNITION POWER
+12VDC BATTERY POWER
TO CHASSIS GROUND
FUNCTION
FOR AWM-820
WIRING COLOR CODE
