6
8. Release video screen from locked position. Lower video screen to viewing position for access to
mounting locations in top of video system housing.
9. Raise video system into approximate position and
connect all wiring to components. Route video cable
through notch in mounting bracket. Connect
wiring and cabling to video system per instructions
included with video system.
10. Check function of all components and lights. See
operating instructions for video system operations check.
For further assistance, refer to the video system manual
for the technical support phone number listed for your
area.
11. Insert video system into opening in console.
Note: Make sure that wires do not get pinched
between bosses on video system and console.
Align holes in housing with clips in mounting bracket. See
Figure 8.
Secure using (4) four 6-32 X 3/4" screws (item 4 pg 2) and (4)
four 3.5 mm washers (item 5 pg 2).
Caution: Do not overtighten screws.
12. Raise video screen into locked position.
13. Carefully remove (2) two spring clips from
rear of O.E.M. console and insert in slots in
bracket on console previously installed. See
Figure 9.
14. Connect wire harness to O.E.M. console and install
in original position. Secure front of console using
(1) one # 8 x 1 1/4" screw (item 2 pg 2).
Caution:
Do not overtighten screws.
Make sure clips at rear
of console are snapped firmly into tabs on O.E.M.
console. See Figure 10.
FIGURE 9
FIGURE 8
FIGURE 10
