TYPICAL CHRYSLER APPLICATION (See Figure 2.)
Radio Preparation:
NOTE: For Chrysler car installations, use the Chrysler Hardware Kit, Part Number 150-1332
1. Select two of the three mounting tabs provided (Items # 7, # 8 and # 9) and match the radio
mounting style of the vehicle as shown in Figures 3, 4 and 5.
NOTE: The tab number is stamped on the bottom of the tab.
2. Attach the mounting tabs to the radio chassis with the four 1/4” hex head screws provided.
3. Attach the 12-pin connector from the harness to the radio.
4. Plug the antenna cable into the antenna socket on the radio.
Installation:
1. Attach the ring lug on the ground wire (black) from the radio side harness along with the
vehicle side grounding strap to the rear of the radio chassis using the short quickie bolt
(Item #2) and the flange nut (Item # 4) provided.
2. Connect the mating side of the harness to the vehicle side wiring harness.
3. Connect the vehicle antenna cable to the radio antenna connector.
4. If a compatible CD changer is to be used with this radio, connect the DIN cable from the
changer to the mating socket on the radio. If an external amplifier will be used for the rear
speakers, connect the low-level output RCA leads from the radio to the low-level inputs on the
amplifier.
5. Re-connect the battery and perform a brief functional test of the radio to verify proper
performance.
6. After verification, turn off the ignition switch and install the radio into the sub-dash of the
vehicle using either the two 10mm hex-head screws (Item #10) provided, or the existing
factory hardware.
7. Re-assemble the dash using the reverse of the disassembly procedure.
RRRRR
AAAAA
DIO WIRINGDIO WIRINGDIO WIRINGDIO WIRINGDIO WIRING
6
INST
ALL
A
T
ION INSTRUC
T
IONS
