8
8
8
8
8
OPEROPEROPEROPEROPER
AAAAA
TTTTT
ING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUC
TTTTT
IONSIONSIONSIONSIONS
bs
THEFT-DETERRENT LED
A light-emitting diode (LED) is located on
the chassis behind the front panel, and is
visible when the panel assembly is swung
down. The LED will flash when the front
panel is removed from the front mounting
plate. The flashing light serves as a visual
warning to the would-be thief that the unit
has been disabled by removal of the front
panel.
bt
RESET BUTTON
A RESET button is located on the front of
the chassis (front panel must be swung
down to access the button). The reset
circuitry is provided to protect the
microprocessor circuitry and should only
be activated under the following
circumstances as it will erase the time
memory:
1. Upon initial installation after all wiring
is completed.
2. If there is a malfunction of any of the
switches on the unit, pressing the RESET
button may clear the system and permit
a return to normal operation.
bu
CASSETTE DOOR
Open and fold down the front panel of the
unit. Hold the cassette with the exposed
tape edge of the side to be played to the
right and insert it fully into the cassette
door (TAPE will appear on the display
panel accompanied by the cassette symbol
(
) and play direction arrow ( or ) as
the cassette is engaged and begins
playing). When the cassette reaches the
end on the side of the tape being played,
the unit will automatically change direction
of play as shown by the arrow indications
on the display panel.
NOTE: Observe cassette operation
cautions in the Care and
Maintenance section of this
manual.
cl
FAST-FORWARD/REWIND BUTTONS
(
/
)
These buttons cause the tape to move
rapidly in the direction indicated by the
arrows. For example, if the
button is
pushed when the tape is moving from left to
right ( on the display panel), the tape will
fast-forward. If the button is pressed while
the tape is moving from right to left ( on
the display panel), the tape will rewind. To
stop
fast tape movement, lightly push the
opposite button. If the tape is allowed to
fast-forward or rewind all the way to the
end, play will automatically begin again
from that point.
cm
TAPE PROGRAM SELECTOR
To manually reverse tape direction and
play the other side (program) of the
cassette, lightly push both the Fast-Forward
and Rewind buttons
cl
at the same time.
The change of direction will be shown by
the arrows on the display panel.
cn
EJECT BUTTON ( )
Tape playback is stopped and the cassette
is ejected by pressing this button. Radio
operation will automatically resume when
the cassette is ejected.
NOTE: Never leave a cassette engaged in
the player when not in use. Doing
so can cause damage to the
cassette and/or mechanism of the
unit. Always press the eject button
and remove the cassette before
removing the detachable front
panel.
