-4-
4. Repeat the above procedure for the remaining 5 pre-sets on
that band and for the other 4 bands on the unit.
bs
bs
bs
bs
bs
LIQUID CRYSTAL DISPLAY PANEL
The Liquid Crystal Display (LCD) panel displays the frequency,
time, and activated functions.
NOTE:
It is a characteristic of LCD panels that, if subjected to
cold temperatures for an extended period of time, they may
take longer to illuminate than under normal conditions. In
addition, the visibility of the numbers on the LCD may
slightly decrease. The LCD read-out will return to normal
when the temperature increases to a normal range.
bt
bt
bt
bt
bt
CASSETTE DOOR
Hold the cassette with the exposed tape edge to the right and
insert it fully into the cassette door until the cassette is engaged
and begins playing (
PLY
will appear on the display panel). When
the cassette reaches the end on the side of the tape being played,
the unit will automatically change direction of play as shown by the
arrow indications on the display panel.
NOTE:
Observe cassette operation cautions in Care and Maintenance
section of this manual.
bu
bu
bu
bu
bu
&
cl
cl
cl
cl
cl
FAST-FORWARD/REWIND BUTTONS (
/
)
These buttons cause the tape to move rapidly in the direction
indicated by the arrows. For example, if the
button is pushed
when the tape is moving from left to right (
on the display panel),
the tape will fast-forward. If the button is pressed while the tape
is moving from right to left ( on the display panel), the tape will
rewind. To stop fast tape movement, lightly push the opposite
button. If the tape is allowed to fast-forward or rewind all the way
to the end, play will automatically begin again from that point.
cm
cm
cm
cm
cm
PROGRAM SELECTOR
To manually reverse tape direction and play the other side
(program) of the cassette, lightly push both the Fast-Forward and
Rewind buttons
bu
and
cl
at the same time. The change of
direction will be shown by the arrows on the display panel.
cn
cn
cn
cn
cn
EJECT BUTTON ( )
Tape playback is stopped and the cassette is ejected by pressing
this button. Radio operation will automatically resume when the
cassette is ejected.
NOTE:
Never leave a cassette engaged in the player when not in
use. Doing so can cause damage to the cassette and/or
mechanism of the unit. Always press the eject button
and remove the cassette before removing the detachable
front panel.
co
co
co
co
co
CD CHANGER MODE SELECTOR (CD)
This button is used to select the playback mode (radio, cassette
or CD Changer). With each press of the button, a different
playback mode will be selected as indicated on the front panel.
During radio, or tape play, press this button to select operation of
the optional CD changer as shown by “CD-C” and “CdC” on the
display panel. Refer to the CD Changer Controls section on page
5 for specific operating instructions.
If the button is pressed when there is no CD changer connected
to the unit, the
CD-C
and
CdC
indications will briefly appear on the
display panel. The unit will then return to radio or tape operation,
depending on which was the last mode in use when the button was
pressed.
cp
cp
cp
cp
cp
TIME/FREQUENCY SELECTOR (T/F)
This unit can be set so that either the clock time or radio frequency/
tape/CD changer functions will normally appear on the display
Содержание 1285739
Страница 13: ......
