4
a.
Wiring the receiver to the vehicle. Choose a source that only
has power when the vehicle is running. Connect as shown
Using the tap connectors supplied.
i.
Place the unstripped ignition source wire on the run channel
ii.
Place the unstripped red power wire completely
iii.
Fold the tap connector back over the wires and make the
connection by crimping the u-contact down flush with the
plastic insulator.
iv.
Close the top hinged cover until latched.
b.
Black wire- Chassis/Ground. Using ground ring supplied,
i.
Place stripped wire (1/4”) inside connector
ii.
Crimp the connector using a crimping tool to secure the
wire.
Specifications:
1.
Operating voltage: 11.5V-14.5V
2.
Operating current:
Transmitter: 70mA
Receiver: 180mA
3.
Operating frequency: 2.4GHz
4.
Operating temperature: 0
℃
-50
℃
5
Troubleshooting
Symptoms Solutions
The Monitor is not on after the
vehicle is started and vehicle is
in reverse?
Check the monitor and the receiver
wiring and connection.
No video signal appears while
reversing the vehicle?
Check the rearview Camera and the
Transmitter wiring connection.
Video image is not sharp
enough?
Clean the lens of the camera.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
