2
Table of Contents
Warnings
1
Table of contents
2
Product description
2
Packing list
2
Transmitter/Receiver installation
3
Specifications
4
Troubleshooting
5
FCC Statement
5
Product Description
The wireless transmitter and receiver have been developed to convert a
hard wire camera/monitor system to a wireless operation. The following
information contained in the installation manual is for camera backup
systems. Note: this product can be used on any Camera/Monitor system.
Packing List
1.
Transmitter w/RCA Connector-1 qty
2.
Receiver w/RCA Connector-1 qty
3.
Wire connectors:
a.
Tap connectors-3 qty
b.
Ring connectors-1 qty
4.
Installation Manual
5.
Warranty Card
3
Transmitter/Receiver Installation
The transmitter and the receiver must
be installed in the vehicle’s trunk or
interior. The transmitter and receiver are not weather proof and must be
located in a dry location
a)
Wiring the transmitter to the vehicle reverse lamp.
Using the
tap connectors supplied.
i.
Place the unstripped positive lead wire on the run channel
ii.
Insert the unstripped red power wire completely
iii.
Fold the tap connector back over the wires and make the
connection by crimping the u-contact down flush with the
plastic insulator.
iv.
Close the top hinged cover until latched.
b)
Black wire- Chassis/Ground. Using. Using the tap connectors
supplied.
i.
Place the unstripped ground lead wire on the run channel
ii.
Insert the unstripped black ground power wire completely
iii.
Fold the tap connector back over the wires and make the
connection by crimping the u-contact down flush with the
plastic insulator.
iv.
Close the top hinged cover until latched.
2.
Wiring the transmitter to the camera.
a)
Connect the transmitters RCA connector to the Cameras RCA
connector.
Tap/Run Connection
