SUNILDA
ultra highend phono tube amplifier____________________________
Set-up and installation of the Phono Amplifier SUNILDA
After having unpacked your phono equipment set the phono pre- amplifier up at its chosen
place. The power supply should be positioned at a distance from the pre-amplifier by at
least the length of the connecting cable.
Equally, other large electrical consumers should not be positioned near SUNILDA and the
record player. The power supply can be best placed on the floor, however make sure the
power switch on the front of the power supply is visible and within reach.
Only when manipulating this main switch on the power supply SUNILDA is either made
alive or, after having switched off, is completely dead – identification by means of a red
LED at the right front of the power supply.
The LED shines, if the pre-amplifier is switched OFF at the switch on the front of the
amplifier, with the power supply, however remaining alive. The red LED signals that the
power supply is still alive.
In case the amplifier will not be used for a longer period of time, as f.Ex. in holiday times,
make sure the amplifiers power supply case as well is cut OFF !!!!
After having set-up both appliances at first connect power supply and amplifier with the
included CENTRONICS cable and secure the cable against falling out at both ends.
Subsequently connect the power supply to mains voltage by means of the power cord.
Ensure that the power supply is switched OFF with no LED shining at the appliance.
Now start to install the signal lines between the pick—up and SUNILDA. Fix the earth
conductor of the record player to the earth terminal assigned to each input at the back of
the pre- amplifier next to the cinch inputs.
Cable the output of the SUNILDA phono pre-amplifier to your EKLIPSE pre-amplifier using
the appropriate cinch cables.
The pre-amplifier is still cut OFF. When putting the power supply into operation, the red LED
at the right front of the amplifier below the ON – OFF switch begins to shine.
Before you also connect the pre-amplifier, check the settings for the pick-up at the appliance .
