Audiovalve Prometheus 100, Инструкция по эксплуатации

Страница: 7 / 15

Prometheus 100 power mono blocks
OUTPUT TERMINALS
Output connections for the Loudspeakers are provided on the
lower centre of the rear panel. Two pairs of heavy duty
,
gold plated binding posts for each cannel are supplied.
CONNECT your loudspeaker positive terminal to the
amplifier (+) output terminal. Connect your loudspeaker
negative terminal to the ( - ) output terminal.
POLARITY - PHASING
It is important to achieve good stereo imaging in your
listening room. By observing the wiring constructions
above, each power amplifier / loudspeaker combination
should be in phase. If you experience a poor stereo
image and / or a lack of bass, check that the loudspeaker
wiring has been connnected correctly. We recommend that
you use one of the easily obtainable "test - disc" to help
you ensure both phasing and channel orientation are correct.
If in doupt, consult your Audio Valve dealer for advice.
Quality of the connections must be examined to ensure a high
performance trouble free operation is enjoyed.Check that the
connections are tight, but do not overtighten with excessive
use of spanners etc. If bare wires are used, make sure that no
loose strands of wire short across to the other terminals or
the amplifier chassis. When using plugs such as Banana, be
sure tu use good quality one`s with a firm fit.
connecting recommendations for best match:
Speakers between 4-8 ohm impedance please use the two
lower speaker terminals - thats your prefered terminals.
For loudspeaker more then 8 Ohm please use the top two speaker
terminal