Audiovalve Prometheus 100, Инструкция по эксплуатации

Страница: 6 / 15

Prometheus 100 power mono blocks
REAR PANEL
The facilities on the rear panel of the Prometheus may
seem not so complex. The rear panel incorporates all
of the terminals for connecting the input signals and
the output signals to the loudspeaker. A reasonable
understanding of this amplifier and the logical approach
should ensure that you are listening to this amplifier in a
very short space of time without any difficults at all.
Please remember that the AUDIOVALVE Prometheus
power amplifier is a high quality electronic instrument
capable of an exceptional level of performance.
Be sure that you are understanding your requirements fully
before you make any connection to this amplifier.
INPUT TERMINALS
Input terminals for this Prometheus power amplifier are easily
accessible and fitted to the lower centre area of the rear panel.
RCA INPUT . These standard type of RCA terminals are for
use with unbalanced signals from most sigal sources such as
audio preamplifiers.
IMPORTANT NOTE: When you use the RCA jacket, please short
circuit the neg. phase on the XLR jacket to ground ( short circuit pin
1+3 with an wire or separate plug). The amp no like an open neg.
input.
XLR BALANCED INPUT . XLR connector fitted to
the amplifier are for use with balanced line signals from
audio preamplifiers etc. Balanced signals are carried
via a three way cable that connects all three pins at each
of the interconnect cable. Please note, the signal has now
double level !!!!
DO NOT operate this amplifier with both RCA and XLR
cables connect at the same time.