14
To prevent damage to the unit and possible injury, read this manual
carefully and follow all installation instructions. This product has been
checked for proper function prior to shipping and is guaranteed against
manufacturing defects.
Before starting your installation, disconnect the battery’s negative
terminal to prevent damage to the unit, fire and / or risk of inju
-
ry.
For a proper performance and to ensure full warranty coverage, we
strongly recommend to get this product installed by an authorized HELIX
dealer.
The HELIX SDMI25 may only be installed in vehicles which have a
12 Volts negative terminal connected to the chassis ground. Any other
system could cause damage to the device and the electrical system of
the vehicle. Install your SDMI25 in a dry location and ensure that it is not
appreciably warmed up by other components close to it. Do not mount
the device near to electronic controls of the vehicle.
For safety reasons, the SDMI25 must be professionally installed. There-
fore, the device should be secured to a solid mounting surface using
proper mounting hardware. Before mounting, carefully examine the
area around and behind the proposed installation location to ensure that
there are no electrical cables or components, hydraulic brake lines or
any part of the fuel tank located behind the mounting surface. Failure
to do so may result in unpredictable damage to these components and
possible costly repairs to the vehicle.
Prior to installation, plan the wire routing to avoid any possible damage
to the wire harness. All cabling should be protected against possible
crushing or pinching hazards.
General instructions
